MDLUU · Slotted and needle winding tools
Five slotted tools and a needle tool with storage case
Measurements and compatibility
- Pack
- Five slotted tools and one needle tool
- General slot
- 6.5 mm deep per listing
- Deep slot
- 10 mm per listing
When to choose it
Choose this set if you switch between narrow paper and wider strips and want the tools in one case. The seller gives a 6.5 mm depth for the general slot and 10 mm for the deep-slot tool. Choose by the width that has to sit inside the slot, not the length of the handle.
The plain needle gives you another way to start a coil. Try it on the same paper as the slotted tool to compare the center. If you work with one strip width only, a single tool can cover that setup with fewer pieces.
Specifications
- Brand
- MDLUU
- Construction
- Manual winding tool set
- Work task
- Roll
- Model
- MDL20200522
- Pack
- Five slotted tools and one needle tool
- General slot
- 6.5 mm deep per listing
- Deep slot
- 10 mm per listing
- Storage
- Case
- Amazon.com reference
- B0891YPJQS
Fit and buying advice
Choose for several tip fits plus a separate needle. Check the exact tool against wide paper.
Related choice Four slotted winding tools with fine, long and wide tips ↗
Questions about this product
Which tip should I try for a ten-millimeter strip?
Start with the stated deep-slot tool and see whether the strip seats evenly along the tip.
Does the needle tool have a slot?
The kit identifies a separate needle and slotted tools. Use the needle when you want to guide the strip start by hand.
Why compare slot depth instead of handle length?
The slot is the part that supports the strip edge. Handle length affects how you hold it rather than which strip fits.
